Julia Setup And Installation
Removing carriage board – Julia Extended.
Last Updated: November 5, 2025A carriage board is a small board mounted on the carriage. To remove the carriage board, follow the steps below. Note: Remove filament before removing the carriage cover. 1. Remove carriage cover. The carriage cover is fastened by 2 screws. Please be careful not to drop the split washers along the screws. 2. Remove all...
Using TMC 2209/2208 drivers with MKS 1.4 for Julia Extended Non ABL.
Last Updated: October 29, 2025All Fracktal printers shipped with MKS 1.4 have DRV 8825 drivers. In case you have to update drivers to TMC 2209, you need to change the Jumper configuration and update the firmware. Note: After putting putting new drivers with updated jumper configurations, you need to start the machine to connect to OctoPrint. After turning on...
Changing Material/ filament.
Last Updated: November 5, 2025Fracktal Printers support a wide variety of materials. This article will guide you through the procedure to change filament. To Change the filament we need to unload the existing filament first. Note: While changing filament, always select the filament with higher melting point in filament change settings. ex: If you have used ABS and want...
How to make complete use of your accessories box.
Last Updated: November 5, 2025The accessories box contains these Accessories. Power cable: Please connect the power cable to the power socket in your printer and connect it to 3pin power socket. PTFE Tube: The PTFE tube is used to avoid the tangling of filament and the rubbing of filament against other surfaces. The PTFE tube allows for smooth movement...
Board Driver jumper settings.
Last Updated: November 5, 2025To identify the controller Board version and its motor drivers MKS GEN 1.4 for DRV8825 with 1/16 Micro stepping per step Jumper layout below 0 0 1 16 microsteps / step MKS GEN 1.4 for TMC2208/TMC2209 with 1/16 Micro stepping per step Jumper layout below 1 1 0 16 microsteps / step MKS genL v2.1...